Sound Advice: Get rid of unsightly wires for speakers
- Article by: DON LINDICH
- February 9, 2013 - 5:59 PM
Q: I’m setting up a home theater. I would like to go wireless for the surround speakers, so I can avoid running wires in the attic and fishing them through the exterior walls. Is there a piece of equipment you recommend?
A: An important thing to remember when considering wireless speakers for surround sound is that there will still be wires involved. You need to plug the speaker into the wall to power it, or connect speaker wires to a separate receiving and amplifying unit at the same end of the room.
Outlaw Audio makes high-performance audio components at affordable prices. Its OAWA3 Amplified Wireless Audio System (www.outlawaudio.com) includes a wireless transmitter that connects to your receiver and a receiver-amplifier unit with speaker terminals. Connect the transmitter to your receiver, and connect the receiver/amplifier to your surround speakers with ordinary speaker wire. You now have surround sound without running wires across the room.
The OAWA3 has 20 watts per channel, which should be adequate for most uses because surround speakers typically don’t need nearly as much power as the front array. A complete outfit with transmitter and receiver lists for $319.
There is another solution available for anyone looking to run wires as unobtrusively as possible.
Sewell Ghost Wire Super Flat Adhesive Speaker Wire comes on a spool. When you look at the roll, it looks like white plastic tape. It is about the same width as duct tape and probably not much thicker. It contains two-conductor 16-gauge speaker wire and is insulated on both sides. By making the wire elements wide and thin, Sewell has made speaker wire of seemingly impossible thinness.
The comparison to tape doesn’t end there. The top side of Ghost Wire is white. The bottom is transparent, displaying the two-conductor copper wire. The transparent side has a strong, sticky adhesive that adheres to walls and floors, but does not leave residue if you peel it up.
You can run Ghost Wire across a ceiling or wall and paint over it, rendering it almost invisible, or run it under carpets. Once the wire has been run, you attach special terminal blocks to the ends that provide connections for traditional speaker wire.
I tested Ghost Wire in my home a month ago, running it on the floor when I carpeted a finished game room that previously had a tile floor. Once the carpet and pad were installed it was impossible to tell where the wire was located under the carpet, even feeling with my fingers over the area that I knew had the wire. You really need to try it to see how cool it is.
Sewell (www.sewelldirect.com) makes HDMI Ghost cables, as well, although I haven’t tested them.
Send questions to firstname.lastname@example.org. Get more recommendations and read past columns at www.soundadviceblog.com.
© 2016 Star Tribune